Author Topic: How does this work? (Read 4433 times)

tonguello · « **on:** November 07, 2011, 12:13:22 »

http://playmodb.org/cgi-bin/showpart.pl?partnum=30-28-7630

I know what it is but how does it work? where and how should I attach it? could somehow show me in a pic?

Thanks a lot.

basilsdad · « **Reply #1 on:** November 07, 2011, 15:20:09 »

I will try to post one for you. Have to run downstairs for the parts.
Joe

tonguello · « **Reply #2 on:** November 07, 2011, 15:22:56 »

Thank you Joe!

basilsdad · « **Reply #3 on:** November 07, 2011, 15:35:50 »

Gaston, it clips on to the back of the open 3 unit wall.

You can place it on either side at the top.

Hope this helps.

Joe

tonguello · « **Reply #4 on:** November 07, 2011, 15:42:13 »

oh thanks Joe! but what if you have the window in the frame?... you have to take it out and then place it again?

basilsdad · « **Reply #5 on:** November 07, 2011, 16:19:48 »

You can't use the window frame with it, unless you somehow trim it.

Will have to work on that. It was meant to be used in the open end of the pavilion, without the framework.
Joe

tonguello · « **Reply #6 on:** November 07, 2011, 16:23:46 »

oooooh! that makes sense then!

thank you Joe!!

Giorginetto · « **Reply #7 on:** November 07, 2011, 17:39:35 »

does this attach then to the good old medieval steck

?

tonguello · « **Reply #8 on:** November 07, 2011, 17:51:11 »

I don't think so.
Only to this piece and the frame for the smaller victorian window.

Giorginetto · « **Reply #9 on:** November 07, 2011, 18:06:48 »

I don't think so.
Only to this piece and the frame for the smaller victorian window.