Thanks to everyone so far for your positive feedback on this project! I will try to answer some of the questions as carefully as I can, due to some customizing techniques that may be considered unsafe for younger members. The shirt was derived from several figures to achieve the open shirt design look. The shirt covering the torso was a red vest obtained from sets like 4903, & 3739. The red sleeves can be obtained from any figure with the same color red as the vest, & with flesh colored hands. I recommend the the torso be of the smooth variety from the same figures that the red vest comes from. (You will need to heat the red vest with a hair dryer to spread the opening to accommodate the EKG leads, & this is the disclaimer part CHILDREN NEED TO ASK THEIR PARENTS FOR ASSISTANCE TO DO THIS PROCEDURE!) The figures torso when disassembled, will be painted using TESTORS water based hobby paints White 52244550117, & Israel Early Tan 52244553422. I custom mixed these 2 colors together to match the Klicky's head with an approximate ratio of 2 drops of tan to 1 drop of white, & adjusting amounts depending on figure tint, because of age, & possible previous fading. That particular type of paint has easy water, & soap clean up. After painting the torso, & allowing it to dry, you can apply black chest hair by doodling with a fine point permanent marking pen. After everything is dry, reassemble as before interchanging the figure pieces as desired. As for the EKG leads, if anyone is interested, send me a PM so I can respond appropriately. I cannot post the procedure on the forum due to using straight pins, cutting them with sharp cutting tools, & including them in the assembly of components making it dangerous for children to attempt. I hope this helps.
