PlaymoFriends

General => Direct Service/Parts Queries => Topic started by: playmofire on April 06, 2007, 08:20:16

Title: Tip for scanning plans
Post by: playmofire on April 06, 2007, 08:20:16

When scanning plans, especially where they are a single sheet, the reverse side of the plan often shows through.  To prevent this, put a piece of grey card behind the sheet being scanned. I use a Kodak photographic grey card.  In the examples below, the scan with the grey card has come out a lighter but I find this sometimes happens whether a card is used or not.  The important point is it is clearer.

Title: Re: Tip for scanning plans
Post by: Sylvia on April 09, 2007, 11:49:04

I often have this "show-through" problem when scanning parts sheets, so thanks for the tip! :)9